Week 9 - Challenge 2 - Switch Bezel Design

Draft Analysis:

Draft Analysis report for given component is "OK" with 2.9-3 degree draft angles.

                draft analysis is carried out to check & achieve minimum draft for given component. to do draft analysis, 1st creating the Class A,B & C surfaces is important. Once all surfaces made as per requirment, then click / select feature draft analysis command and choose model and compas positioning. once done choose draft color allocation. then complete analysis of draft analysis is shown.

Tooling Axis:

                Tooling axis is the basic feature to do draft analysis. to create tooling axis, 1st extracting & untrimming the surfaces and exploting them.finally trimming as per requirment. once done, create reference lines after intersecting given model. after bisecting the two reference lines, we get one besected line from those two reference lines. So doing same in 2 planes is needed to get tooling axis. after modelling whole component, this tooling axis will be used as reference to do draft analysis i.e, draft analysis should be done in direction of tooling axis.