Week 8 - Challenge 5 - Door Trim Lower

Drawing type:3D

Draft analysis and Door trim lower

Objective:

The main objective of this challenge is to create the door trim lower component through the given Class A surface by the tooling axis and Draft analysis to the class A and final class C of Door trim.

Tooling axis:

We should keenly observe and study the class A surface to create the tooling axis of the component for the above given Door trim Y axis is the best suitables tooling axis so i tried to create with x,y,z method and i found analysis not clear completely so i did Normal to surface method and it clear the Draft Analysis.

Class A Surface:

Draft analysis for Class A:

Draft analysis for Final Class C:

Close surafce :

Thickness checking :

Final view:

Learning outcome:

1.How to form the tooling axis for door trim lower.

2.To capture Class B and Class C properly.

3.To check the feasibility of the component.