Week 8 - Challenge 3 - Coin Holder Design

Drawing type :3D

Coin holder with Draft Ananlysis

Objective :

The main objective of this challenge is to create the coin holder coponent through the given class A surface by the tooling axis and draft Analysis to the Class A and final Class C of the coin holder.

Tooling axis:

We should keenly observe and steady the class A surface to create the tooling axisfor the coponent,for above given coin holder Y axis is the best suitable for tooling axis so i tried to create tooling axis with normal to surface method and it cleqar the draft analysis.

Class A surface :

Tooling axis :

Draft Analysis for Class A:

Draft Analysis for Final Class C:

Final Class C:

Close surface :

Thickness for Class C:

Learning outcome:

1.How to form the tooling axis for Coin holder

2.To capture Class B and Class C

3.To check the feasibility of the component.