Week 8 - Challenge 5 - Core & Cavity Design

European regulation Measure CL L at sections SA-SA SB-SB SC-SC SD-SD SE-SE and produce CL check chart to validate.✓ At all five sections the CL L value should be greater than 10 mm to satisfy the European regulations.✓ Wheel guard reqmt: The value of 'a' shall be more than 5 mm at a line 30 ^ * forward and 50 ^ * rearward…

hood desgin At the beginning of the 21st Century, laboratory design practices have emerged that place new demands on laboratory ventilation systems and more specifically, on fume hood design. Evolving laboratory chemistries and technologies (such as nanoscale work, genetic engineering, and 3-D printers), open plan laboratories,…

Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if you are getting the undercoating applied after a couple of years, it’s fine too.…

 1. I like to suggest two car in this case . By looking to the customer demand.   Toyota urban mid grade MT            Maruti Suzuki ertiga LXI   Toyota urban mid grade MT                             …

                                        DESIGN OF BOEING 747 -8   Objective  In this we learn how to design and model a Boeing 747 with the given instruction.A Boeing 747 is a passenger aeroplane which has 366…

Development of a Door Trim panel Aim: To Creation of CAD model considering Class A surface, Nominal thickness and Attachment strategy Objective: To Creation of CAD model considering Class A surface, Nominal thickness and Attachment strategy. Create thickened part using master section for reference Create the mounting features…

PART 1  part 2  

DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds to specified values. If the No warning…

DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds to specified values. If the No warning…

========================== DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds to specified…

    DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds to specified values. If the…

======================================= DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any point, corresponds…

===================================================   DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed.This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction at any…

==================================================== TOOLING AXIS The machining process instantiation supports the absolute or relative coordinates for tool axis and machining directions. Go to Tools > Options > Machining > Operation > MP instantiation option. Select MP instantiation checkbox and edit the operation.…

  ==================================================   DRAFT ANALYSIS The Draft Analysis command enables you to detect if the part you drafted will be easily removed. This type of analysis is performed based on color ranges identifying zones on the analyzed element where the deviation from the draft direction…

RADAR MAST YATCH ASSEMBLY     --------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------  …

                                                                       INTRODUCTION   In this we lear about desgin of american chopper…