Week 8 - Challenge 4 - Coin Holder Design

COIN HOLDER

STEPS FOLLOWED:-

1. TOOLING AXIS

2. B SURFACE CREATION

3. C SURFACE CREATION

4. FINAL BODY

1. TOOLING AXIS

IN THIS PROJECT, THE TOOLING AXIS IS MADE NORMAL TO THE SURFACE.

WE HAVE TAKEN INTERSECTION AND AS WE KNOW IF THE SURFACES ARE AT 90 DEG OR FLAT THEN THE TOOLING AXIS SHOULD BE TAKEN NORMAL TO THE SURFACE.

HENCE, IN THIS PROJECT WE HAVE TAKEN TOOLING AXIS NORMAL TO THE SURFACE.

B SURFACE CREATION

B SURFACE CREATION IS DIVIDED INTO 4 SUB SURFACES

i. SIDE WALLS, ii. BASE, iii. TOP WALLS, iv. OUTER FLANGE

i. SIDE WALLS

COMMAND USED:- EXTRACT, UNTRIM, EXTRAPOLATE, TRIM, OFFSET

ii. BASE

COMMANDS USED:- EXTRACT, UNTRIM, EXTRAPOLATE, TRIM, OFFSET

iii. TOP WALLS

COMMANDS USED:- MULTIPLE EXTRACT, EXTRAPOLATE AND OFFSET

iv. OUTER FLANGE

COMMANDS USED:- MULTIPLE EXTRACT, EXTRAPOLATE, OFFSET AND TRIM

FINALLY BY USING TRIMS AND REQUIRED FILLETS, WE GET AND FINAL CLASS B SURFACE.

C SURFACE CREATION

COMMANDS USED:- MULTIPLE EXTRACT AND SWEEP

EXTRACT OUTER FACES OF CLASS A SURFACE AND THE SWEEP IT.

THEN BY USING FINAL TRIMS WE GET FINAL OUTPUT

THEN GO INTO PART DESIGN WORKBENCH AND USE COLSE SURFACE COMMAND

DRAFT ANALYSIS

A. DRAFT ANALYSIS ON PARTBODY

B. DRAFT ANALYSIS ON CLASS A SURFACE