Week 8 - Challenge 4 - Bumper

Week 8 - Challenge 4 - Bumper

Create the Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Take the Thickness of the component to be 3 mm

Given geometry

# tooling axis

create apoint

create a cordinate system

intersection by xy

creating dummy axis1

inersection to find dummy 2 axis

bisecting line to find dummy tooling axis 2

creating tooling axis by bisecting the two dummy axis

final tooling axis

DRAFT ANALYSIS IF CLASS A

#CREATING CLASS B SURFACE

create an extract

creating 3 mm offset

correct all dis joint offest surface

createing a boundry

missing3.5mm fillet

join disjoint surface

now to correct this region

using boundry and and multiple multi section surface join the region

correting this region

create a spline

#CREATION OF CLASS C SURFACE

now to join etrapolate and trim edges

#JOIN A WITH C SURFACE

CHECK FOR NON INTERSECTION AREA

correcting the error

no boundry found system complytl closed

Draft analysis for solid body

Tree structure