Week 8 - Challenge 4 - Bumper

Aim-

Create a Bumper Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Make the Thickness of the component to be 3 mm

INTRODUCTION:

CLASS-A SURFACE:

A surface made by the designer is given as an input to the plastic modeler to work on. It is an aesthetic surface and the outermost surface.

CLASS-B SURFACE:

The surface below a certain thickness from the class-A surface is the class-B surface. This is the surface that contains engineering aspects of a model.

CLASS C SURFACE:

A surface that joins class-A and class-B surfaces is a class-C surface.

TOOLING AXIS-

Draft Analysis FOR CLASS A:

# Close surface draft analysis-