Week 8 - Challenge 3 - Switch Bezel Design

Aim: To create Switch Bezel Design by creating Class A, B, C surfaces.

Objective: To create a Design and perform a draft analysis on it.

Introduction:1. Class A surface: A surface that is given to the plastic modeler which is of aesthetic and outermost surface. The surface made by
the designer is known as a Class A surface.
2. Class B surface: A surface that is below the Class A surface, at a certain thickness, which contains engineering aspects on it is
known as Class B surface.
3. Class C surface: A surface that joins the Class A and Class B surface is known as a Class C surface.

Procedure:
1. Creating a tooling axis
2. Performing draft analysis
3. Creating a Class B surface
4. Creating a Class C surface
5. Creating a solid model.