Week 8 - Challenge 2 - Switch Bezel Design

SWITCH BEZEL

• firstly creating the tooling axis with normal to surface , for this challenge tooling axis will also create with th bisecting method but it satisfing the all conditions with normal to surface so i have considered in normal tp surface method
• after creating tooling axis draft analysis is done on the Class A surface for knowing whether it clearing all surfaces or not
• after that extracting the surfaces from the Class A ,untrimmed ,then extrapolited and offseted and trimmed with all surfaces for aquring the Class B surfaces.
• appling the fillets on the edeges
• extracting the boundary for sweeping anlong with the Drafting angle for creating the Class C surface
• the joining the Class A with the Class C (sweep) and trim with the Class B for getting the closed surface(component)
• then go to part desgin work bench for filling the material in closed surface for getting component
• again draft anylsis should done for checking whether it satisfing or not
• thickness of the surface is taken 2.5mm

All picture and catpart is attached below for your reference