Week 8 - Challenge 2 - Switch Bezel Design

Aim:- To Create the Switch Bezel Plastic component through the given Class-A surface. To begin with, the tooling axis for the given Class-A Surface should be created meeting the requirements of the draft angle and at the end perform the Draft analysis on the model.

Tooling Axis:-

Here, Tooling Axis was taken normal to the base surface by taking a point on it and the creating a line normal to the surface which ultimately forms the tooling axis.

Draft Analysis on Class A:-

Here 3 Degree draft angle was taken to do the draft analysis and the analysis shows that it is a safe angle for ejection of the part smoothly.

Draft Analysis after final part :-

The post part raft analysis shows some red that is zero to 3 degree draft, hence the draft was reduced to 2.9 degree which resulted in less red edges. Rest part was shown green which is safe for ejection of the part.

Geometrical Sets And Part Body :-

• Screenshots of the solid model with the proper color code of the draft angle in various orientations (Isometric, Front, Side, and Top View)

Isometric View:-

Front View:-

Back View:-

Left Side View:-

Right Side View:-

Top View:-

Conclusion:- All screenshots of various part views and draft analysis was added in the report.