Week 8 - Challenge 2 - Base Bracket Design

Master Section Development AIM: To Create the Closed part body of B PILLAR from given Class-A and develop attachment features. OBJECTIVE: The objective of this challenge is to develop Closed Surface Model using Master Sections and develop attachment features for fixation of parts by following OEM Design standards and procedures…

COIN HOLDER AIM: To Create the Solid part body of COIN HOLDER from given Class-A surface. OBJECTIVE: The objective of this challenge is to create COINHOLDER DESIGN along with Solid Part Body from Class-A surface. INPUT CLASS-A SURFACE: SOLID PART BODY:   DESCRIPTION: Four stages of design life cycle are as follows:…

Base Bracket Design AIM: To Create the Solid part body of BASE BRACKET from given Class-A surface OBJECTIVE: The objective of this challenge is to create BASE BRACKET DESIGN along with Solid Part Body from Class-A surface following OEM design standards in CATIA SURFACE WORKBENCH and PART DESIGN. INPUT CLASS-A SURFACE:…

Switch Bezel Design AIM: To Create the Solid part body of SWITCH BEZEL from given Class-A surface. OBJECTIVE: The objective of this challenge is to create SWITCH BEZEL DESIGN along with Solid Part Body from Class-A surface. INPUT CLASS-A SURFACE: SOLID PART BODY: DESCRIPTION: Four stages of design life cycle are as follows:…

Door Applique Design with Engineering Features AIM: To Create the Heat Stakes and the locators for given Class-A Surface of Door Applique. OBJECTIVE: The objective of this challenge is to create Heat Stakes and the locators along with solid part of given class-A surface of DOOR APPLIQUE following OEM design standards in…

CORE AND CAVITY BLOCKS FOR THE SWITCH BEZEL. AIM: To create core and cavity blocks for SWITCH BEZEL. OBJECTIVE: The objective of this challenge is to create Core and Cavity block along with Close surface model for SWITCH BEZEL following OEM design standards in CATIA SURFACE WORKBENCH and PART DESIGN. SOLID PART BODY: DESCRIPTION:…

DUE TO ERROR IN IGES PART, I CONTACTED SUPPORT TEAM THIS IS THE COPY OF RESPONSE I RECEIVED.   DESIGN Domain - CLASS A INPUT ERROR Nirmal M <support+608e9aa0de2a7@skill-lync.com> Tue, May 4, 2021 at 6:34 PM Reply-To: Skill-Lync Support <support+608e9aa0de2a7@skill-lync.com> To: rohankashid95@gmail.com…

RIB FOR THE CENTRE CONSOLE COIN HOLDER. DESIGN CONSTRIANTS   DRAFT ANALYSIS OF FINAL PRODUCT   DRAFT ANALYSIS REPORT Draft Angle: The draft angle is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). As plastic cools, it shrinks and…

Draft Analysis on a Fan Cover:     DRAFT ANALYSIS Draft Angle: The draft angle is the amount of taper for molded or cast parts perpendicular to the parting line. It can be measured in degrees or mm/mm (in/in). As plastic cools, it shrinks and therefore shrinks onto molding surfaces. Because of this and a few…