Week 8 - Challenge 1 - Base Bracket Design

Aim: To find the section modulus of the hood and optimization to improve the overall section modulus. Objective: Use the section from your Hood design and calculate the section modulus using the formula S= I/y.                                …

                                                   FENDER DESIGN - WHEEL ARCH  Aim:      To calculate the Wheel Arch gap at required points and check whether the…

                                                                              BENCHMARKING      -> Benchmarking…

DOOR TRIM WITH B SIDE FEATURES(DOG HOUSE):      Dog House is an engineering feature used in plastic trim design. Dog houses are used as supporting feature. Sometimes other engineering features like snaps; locators etc. are mounded on them to increase their strength Aim:      To design…

  DOOR HANDLE WITH B SIDE FEATURES(RIBS AND SCREW BOSS):      Ribs are generally designed on the non-appearing surface of the plastic part, and its direction is as close as possible to the flow direction of plastic melt filling. Ribs should neither be too long nor too thick, otherwise, it will increase…

SWITCH BEZEL Aim:      To design the complete solid model of Switch Bezel with the help of Class A surface(input) by creating the tooling axis and analysing the draft angle. Draft angle:     Draft angle (the degree of taper of the side wall of the mold or the angle of clearance designed to aid…

  COIN HOLDER       It is plastic component helps to keep and hold the coins to pay tolls. Back in the day, there was no such thing as a “transponder” or digital payment systems. Instead, you had to actually stop your car at a toll booth and either hand the person who worked in that…

BUMPER      A device for absorbing shock or preventing damage (as in collision) specifically, a bar at either end of an automobile.  The plastic material which is used for the manufacturing of bumper is ABS(Acrylonitrile Butadiene Styrene). Aim:       To design the…

SWITCH BEZEL Aim:      To design the complete solid model of Switch Bezel with the help of Class A surface(input) by creating the tooling axis and analysing the draft angle. Draft angle:     Draft angle (the degree of taper of the side wall of the mold or the angle of clearance designed to aid…

Base Bracket Aim:      To design the complete solid model of Base Bracket with the help of Class A surface(input) by creating the tooling axis and analysing the draft angle. Draft angle:     Draft angle (the degree of taper of the side wall of the mold or the angle of clearance designed to aid…

                                                                       HOOD      Hood is the main component of a car at the front…

                                                    UNDERBODY COATING      The Underbody coating is usually a dense cladding (based on rubber material) which is applied on the…