Week 8:- 3D Finishing Challenge 2

Points Need to Be Taken Care of While Finishing the Design:

The following are the points taken into consideration while finishing the design.

1. Hole Concentricity and Hole Sizes:

All part holes' concentricity and hole sizes are checked for easy assembly while finishing the parts.

2. Machining Area:

The machining area in every part should be defined and the machining area should be highlighted by using standard colour code. Machining is to be done on parts to properly Mount with mating parts. Machining only on desired faces reduces cost and save time. And also Machining increases accuracy of dimension. So before going to simulation or detailing machining area should be defined.

3. Nominality:

All unit’s dimension should be maintained nominal to facilitate easy assembly of the unit.

4. Holes Colouring Standard:

In a 3D finish hole colouring should be done because it helps to identify what type of hole it is. It depends on customer standards. Customer specific colour like:

Dowel hole should be given blue colour.

Threaded hole should be coloured with yellow.

Counter bore, open hole should be given cyan blue colour.

5. Pneumatic Lay outing:

Pneumatic lay outing is collection of different pneumatic pipes which work as a inlet to the pneumatic cylinder. It should be done properly for proper functioning of the units.

6. Gaps Checking:

The gaps between the different units are checked to ensure the proper individual working of different units.

7. Fasteners Implementation:

Fast should be implemented in all the units as per the requirement and load on the part.

8. Avoiding Clash Between Different Parts:

Proper gap should be maintained between units to avoid the clashes between the different units.

9. Mylar Splitting as Per Panel Profile:

Mylar splitting as for panel profile should be confirmed while finishing the design.

10. Proper Renaming of Parts or Assemblies as Per the Standards:

Proper renaming of parts and assembly should be done while finishing the design and hence we can identify each and every part easily with Unique Identification.