Week 7 Challenge - Assembly Workbench

For Drawing 1 and 2 I have attached the same files as per the above requirements .

For Drawing 1 or CV Joint , I took Basic approach of making three seperate parts using plastic modeling in which I used sets of geometry and body to design my part.

And then to assemble them I used simple concentric and surafce contact constraints to assemble different parts. Please go through the assembly, for further understanding.

For Draiwng 2 or Quick Return mechanism, I took basic approach of making five seperate parts using plastic modelling in which i used sets of geometry and body to design all parts.

And then to assemble them, I used some publications and simple concentric, surafce contact and offest constraints to assemble all the parts . Please go through the assembly, for futher understanding.

Note: It's been a while since I had submitted any assignment , really sorry for delay but due to some technical issues I was not able to continue my classes as well. I would love to continue this as smoothly as it can .