Week 4.1: Project Steady state simulation of flow over a throttle body
Steady state simulation of flow over a throttle body
Import the STL file to covnerge make a dignosis test if any error clear it
make a case set up
Remove the fence of the boundry
and patch using repair tool
Simulation Time Parameters:
Start Time:0 Cycle
End Time:15000 cycles
Boundary Conditions:
Inlet Pressure:150000Pa
Outlet pressure: 100000Pa
Elbow and Throttle Plate: Wall Type Boundary Condition(law of wall)
Where as on inlet as Inflow other as Outflow
Material:
Air is Used as a Fluid material while simulating flow over Throttle Plate.
Mesh:Mesh Size taken is 2e-3 m in x y and Z direction where as Fixed embedding of 3 layers and scale of 2 is applied near the throttle plate
boundary.
after all the process Run the code using command phase and post process the result exibit in the paraview and run the simullation
Plots and links are given below