Week 11 - Project - A pillar Design with Master Section

Drawing type:3D

A pillar with Dog house and Draft Analysis

Objective :

The main Objective of this challenge is to create the A pillar coponent through the given class A surface by the tooling axis and Draft analysis to Class A and Final Class C of the A pillar.

Tooling axis:

We should keenly observe and study the class A surface to create the tooling axis for the component for the above given A pillar Y axis is the best suitable axis so i tried to create with x,y,z method i found that the draft analysis not clear completely so i did Normal to surface method and it clear the Draft Analaysis.

Draft Analysis for Class A:

Draft Analysis for Class C:

Draft Analysis for Dog house:

Draft Analysis for final A pillar:

Class A surface:

Class B surface:

Class C surface:

Close surface:

Final A pillar:

Learning outcome:

1.How to form the tooling axis for the A pillar.

2.To capture Class B and C properly.

3.To check the feasibility of the component.