Week 11 - Project - A pillar Design with Master Section

  https://drive.google.com/file/d/1KgCRxqafOFeswANMuqwKXPWD_74ps7N7/view?usp=drive_link       MODELING OF AMERICAN CHOPPER IN SOLIDWORKS   Objectives- The main objectives of this project are: To create individual parts of chopper using solidworks To assemble all the individual parts into chopper…

https://drive.google.com/drive/folders/14SPCLEEhI21bM0ubGl3Jgrx8eRx_9Wsp?usp=drive_link Project completed.

complete project.

completed project 

AIM: TO FLATTEN THE WIRING HARNESS AND DRAFT THE WIRING HARNESS ASSEMBLY. GIVEN: HARNESS ASSEMBLY: HARNESS FLATTENING: WE GO TO THE HARNESS FLATTENING WORKBENCH AND DEFINE THE FLATTENING PARAMETERS. WE USE THE EXTRACT COMMAND TO BRING THE HARNESS ASSEMBLY TO THE FLATTENING WORKBENCH HERE. CHOOSING A SUITABLE PLANE WE FLATTEN…

Check the bundle Continuity. Add snap of result in submission Add annotation to all connectors. Make an assumptions for annotations like connect 1 , 2 etc Generate CAT.part of harness assembly and convert is in. igs format.

Aim:  1) To Route the following harness layout in the Electrical workbench. 2) Add protective covering on all branches connected to DT06-2S & DT06-4S connectors. Given: CAD data of the following Connectors:  DT06-4S DT06-6S DT06-2S DT06-08SA Connectors Layout Design: Steps to be followed: 1. Download…

 AIM:   To solve the above assignment questions and define the necessary electrical properties in the respective workbench.   OBJECTIVE:   To download the P-Clamp CAD data and define it as Electrical Support in the Electrical Part design workbench and also define the necessary electrical properties.…

completed

completed.

complted.

 Section Modulus Calculation Of Hood Aim  To calculate the section modulus of the previously designed hood for analyzing its strength and also optimizing the design to see the difference in the bending strength of the hood. Higher the section modulus of a structure, the more the resistive it becomes to bending.…

Hood Design in UG NX If fig not show I have attached in zip file. Objective Design hood outer panel, inner panel and reinforcements with the given outer hood skin, master section and design parameters.   Introduction The hood or bonnet is the hinged cover over the engine of motor vehicles. Hoods can open to allow…

completed

A-PILLAR DESIGN WITH MASTER SECTION   AIM: To create the A Pillar Design with the master section given as the intersection sketch with the Class A surface and create the tooling axis and perform the Draft analysis for the final solid part. CLASS A SURFACE:           Class A is an aesthetic surface with the highest quality…

completed  

completed  

completed

completed

completed  

completed

sir in challenge 5 I have submitted wrong file. please check  For that challenge, I have attached the same assembly file by mistake.   please check