Week 10 - Challenge 3 - Door Trim Lower with Engineering Features

Drawing type:3D

Door applique with engineering features and Draft Analysis

Objective:

The main objective of this challenge is to create the Door applique component through the given Class A surface by the tooling axis and Draft analysis to the Class A and Final Class C of the Door applique.

Tooling axis:

We should keenly observe and study the Class A surface to create the tooling axis for the component for the above given Door applique y axis is the best suitable tooling axis so i tried to create with x,y,z method i found that the draft analysis not clear completely so i did Normal to surface method and it clear the Draft analysis.

Draft Analysis for Class A :

 

Draft Analysis for Final trim:

Draft Analysis for Features:

Class A surface:

Class B surface:

Class C surface:

Final trim:

Close surface:

Featues:

Learning outcome:

1.How to form the tooling axis for Door applique.

2.To capture Class B and Class C properly.

3.To check the feasibility of the Component.