Week 10 - Challenge 2- Attachment Feature Creation (Dog House)

Drawing type :3D

Door trim witn Draft Analysis

Objective :

The main objective of this challenge is to create the Door trim component through the given Class A surface by the tooling axis and draft analysis to the Class A and final Class C of the door trim.

Tooling axis:

We should keenly observe and study the class A surface to create the tooling axis for the component for the above given Door trim y axis is the best suitable tooling axis so i tried to create with x,y,z method i found that the draft analysis not clear completely so i did Normal to surface method and it clear the draft Analysis.

Draft Analysis for Class A:

Draft Analysis For Class C:

Draft analysis for Final Door trim:

Class A surface:

Class B surface:

Class c surface :

Final Trim:

Close surface:

Thickness:

Dog house Values:

Draft analysis fo Dog house:

Learning outcome:

1.How to form the tooling axis for Door trim.

2.To capture Class B and C properly

3.To check the feasibility of the component.