Introduction to National Building Code and Steps in a Construction project

2:-aim:-

From the National Building Code list the groups that will be essential to you when you begin modeling in Autodesk Revit.

ans:-a) RESIDENTAIL BUILDING, B) INDUSTRAIL BUILDING, C) EDUCATIONAL BUILDING, D)ASSEMBLY BUILDING,E)STORAGE BUILDING, F) HAZARDUS BUILDING ,F) MERCANTILR BUILDING

3:- AIM:-

List the five major steps that occur in project cycle . The steps should include from conceptualization of project to maintenance and final stage.

ANS:-1) INITATION 2) PLANING 3)EXECUATION 4) CLOSURE

4:- AIM:-Give examples of different disciplines involved in construction of a project

ANS:- 1)- CONSTRUCATION, 2) FINAACE AND ESTIMATE ,3) CONTRACTS AND BID, 4):- GEOTECHNICAL, 5):-MANAGEMENTS,6)- STRUCTRL, 7) SURVEYING

5:-AIM:- How are buildings classified ? Place the following buildings under each category

ANS:-A) FOUR UNIT APARTMENT-GROUP A- RESIDENTIAL BUILDING

B)-SCHOOL WITH CAPACITY OF 1000 STUDENTS- GROUP B;EDUCATIONAL BUILDING

C)A SINGLE UNIT SHOP:-GROUP E MRECANTILE BUILDING

D) MULITY STORY SHOPPING COMPLEX- GROOUP E MRECANTILE BUILDING

E)- STEEL MACHINE FACTORY- GROUP H- INDUSTRIAL BUILDING

6:-AIM:-Distinguish the roles of Design team and Management team

ANS:-DESIGN TEAM:-

• HELPS TO FINALISE PLAN
• EVALUATIONARIES IN THE PROJECT
• IMPLEMENTATION THE PROJECT

MANAGEMENT TEAM:-

• ACCOMPLISHEMENT OF PROJECT
• EXECUATE THE DESIGN
• ACHIEVES THE SATISFACATORY COPLEECATION OF THE PROJECT

7:-AIM:-Refer to NBC, Identify the modeling requirements for the project ( from week 4).

HEIGHT OF BUILDING

• THE HT OF BUILDING SHALL NOT EXCEED 15 M
• HOUSING FOR THE LOW -INCOME GROUP SHALL PREFERABLY BE UP TO A MAX TWO STOREY

AREA LIMITATION:-

ACCORDING TOTHE NBC 2005, THE MIN PLOT SIZE WITH GROUND COVERAGE NOT EXCEEDIND 75% SHALL NOT LESS THEN40 SQM. IN SMALL AND MEDIUM TOWN AND NOT LESS THEAN 30 SQM. IN MEREOPOLITIN AREA.

ROOM SIZE:-THE MULTIPUROSE SINGLE ROO SHOULDE BE 12.5 M^2 . IN HOUSE TWO ROOM ONE ROOM SHALL NOT LESS THAN 9 M^2 MIN WIDTH 2.5 M,AND 2ND ROOM SHALL NOT LESS THAN 6.5 M^2 MIN WIDTH 2.1 M

• WALL HEIGHT:-
• HABITABLE ROOM:-2,75 M
• KITCHEN-2.6 M
• BATH/ WC-2.2 M
• CORRIDORS-2,1M

1:-AIM:Why are building codes or standards essential for the modeling/ efficiency of drawings in Revit ?

• A SET OF STANDARDS THAT ARE UNIFROMTO ALL STR
• IT PROTECTS THE CONSTRUCATION SEFTY
• MODERNCONSTRUCATON METHOD
• PROVIDES BUILDING STANDERTS.