Identification of Cracks

QUE 1 : What is the mode of failure or damage of the beams in the figure above? Are the damages repairable? Elaborate

A)

Crack is formed due to flexural failure in beams. As we can see that damage is caused more to the beam then column. Damage is caused due to insufficient of reinforcement or concrete. To overcome this failures steel must be provided at top/bottom of beam. This damages are repairable, while repairing this we need to remove pipes ,wires and turn off the water and power connection. It can be repaired by adding cement to the damaged part.

B)

This cracks are formed due to high slump concrete. Beams and columns carry heavy load. So ,first step is to relieve part of its load. This is done by providing supports at beam column joints. Remove the damage concrete until corred steel reinforcement is visible.

C)

Cracks are formed due to beam column connection failure. It occured due to high shear forces during seismic activity. If it is not properly repaired excessive loss in strength ,then structure will collapse.

Question 2:

A)

It is formed due to the failure in column due to buckling. Buckling is the sudden change in shape of a structural component under load. If a structure is subjected to gradually increase in load ,member may suddenly changes the shape'

B)

Due to Shear failure in column. Lateral loads carried in vertical elements of structure. Size of columns is increased in direction of shear to increase shear capacity. High shear forces are attracted by shorter columns. These failures occur during earthquake at open ground floor level.

C)

It is formed due to short column failure. Short columns fail by crushing at very high stress levels that are above the elastic limit of column material. It is a critical type of concrete column damage occurs at these columns.