Hood design-Week 2

1.Today I submitted hood inner, outer panel assembly with hinge and Latch reinforcement

2. I am not following the above quation fully I am not draw the fornt relief 200 mm

3, Firts I mirror hood inner and outer panel after the thicken, before thicken i cant sew the surface.

4. I am facing problem here to do mirroring surface, the surfece not mirroring with all feature.

5. in this design i use the

a. Offset the curve

b. Offset the curve on surface

c. Offset th surface

d. Through curve

e. sketch

f. face blent

g. mirror feature

h. law extension

i. trim curve etc.

please check my attached design document and give the feed bach to me