Drafting of various geometries using Chamfer, Fillet tool in AutoCad

1. Ans :

       AIM :

         To draw the given diagrams using Fillit and chamber tools to execute angle and curvature of the diagram.

INTRODUCTION :

   Draw each diagrams using autocad commands like line , circle , trim, fillit and chamber to create the diagrams as per above mension.

Procedure :

      Diagram : 1

•         Draw line using line command with length of  3 m
•    Make line with dimension of 2.12 m < 45degree
• Make line with dimension of 2.83 m < 135degree
• And draw line of 2 m
• And close the diagram
• From the orgin point make line of 1.5 in X axis and 1 m in Y axis 
• From the end point make circle of dia 1.20 
• From the orgin point make line of 1.5 in X axis and 2.5 m in Y axis 
• From the end point make circle of dia .80
• Mark the dimensions using dimension command of command prompt

Diagram :2

• IN this diagram change the value of decimal to arcituctural 
• And start using measurments in feet and inchs
• Horizonatal line of 8'
• Vertical draw the line of  1'9
• After that using angle of 2' 10 <225degree
• After that of length 2' < 180
• After that of length 2'6 < 45 degree
• After that of length of 3' < 45 degree
• And the diagram closed

This procedure is same for all diagrams where measurement can be change to decimal , engineering and arcituctural etc

Result :

   From procedure we are concluding that the all diagram are drawn with given measurements and dimensions along angle etc by using fillet and chamber command and the drawn diagrams are attached below for your reference.