Creating a Floor plan, Footing detail and Isometric view using AutoCad

1. Ans,

AIM :

To draw the above diagrams using autocad tools

Introduction :

To draw the given diagram using any of the following coordinate system like,

1. Direct coordinate system

2. Absulate coordinate system

3. Relative coordinate system

Diagram C1 :

• Draw line with 0.9 using direct coordinate syste
• continues line vertical of .25
• continues line -X axis wiht .2
• continues line +y axis with .4
• continues line -X axis wiht .05
• continues line +y axis with .4
• continues line -X axis wiht .05
• continues line +y axis with .4

• continues line -X axis wiht .05
• continues line +y axis with 1.65
• continues line -X axis wiht .3
• continues line -y axis with 1.65
• continues line -X axis wiht 1.2
• continues line +y axis with .15
• continues line +X axis with .3
• continues line +y axis with .15
• continues line +X axis with .3
• continues line +y axis with .15
• continues line +X axis with .3
• continues line +y axis with .15
• continues line +X axis with .3
• continues line + x with 1.2 from the line of footing .30 dimension
• continues line from +.6 and ends at 1.2 towards -X axis

Hence the diagram C1 is drawn with given coordinates

Result :

As per the above steps for Diagram C1 which is same procedure for all 6 diagrams hence all diagrams are drawn and attached below which is for your reference hence commands executed.