Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad
Q1.
AIM : To create a layout of the Plan and Section A of the project in Challenges 7, using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot.
PROCEDURE
STEP 1 :
To create the view port as shown in the figure open the AutoCAD file which is been created during challenge 7
STEP 2 :
Type VIEW in the command box aand press enter. Then, view manager dialogue box will appear then sekect new and name the view name as view name as plan and section and press ok and select the view as plan and section and press set currect and press ok.
STEP 3 :
Type LAYOUT in command box and press enter, the that select NEW and give the name of layout as plan and section
STEP 4 :
Go to page setup manager and select plan and section and modify the settings
STEP 5 :
Type MV and Multiview and press enter select 2 view port and vertical and press enter and adjust the view in the view ports
RESULT :
The given challenge is done by using necessary tools in AutoCAD
Q2.
AIM : To create a layout of the Kitchen drawn in Challenge 9 as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot.
PROCEDURE
STEP 1 :
To create the view port as shown in the figure open the AutoCAD file which is been created during challenge 9
STEP 2 :
Type VIEW in the command box aand press enter. Then, view manager dialogue box will appear then sekect new and name the view name as view name as kitchen and press ok and select the view as kitchen and press set currect and press ok.
STEP 3 :
Type LAYOUT in command box and press enter, the that select NEW and give the name of layout as kitchen
STEP 4 :
Go to page setup manager and select kitchen and modify the settings
STEP 5 :
Type MV and Multiview and press enter select 4 view port and horizontal and press enter and adjust the view in the view ports
RESULT :
The given challenge is done by using necessary tools in AutoCAD
Q3.
AIM : To create a layout of the section created in Challenges 9.Use scale as mentioned in the Figure. Use MV command create multiple viewports. Take a plot.
PROCEDURE
STEP 1 :
To create the view port as shown in the figure open the AutoCAD file which is been created during challenge 9
STEP 2 :
Type VIEW in the command box aand press enter. Then, view manager dialogue box will appear then sekect new and name the view name as view name as section and press ok and select the view as section and press set currect and press ok.
STEP 3 :
Type LAYOUT in command box and press enter, the that select NEW and give the name of layout as section
STEP 4 :
Go to page setup manager and select plan and section and modify the settings
STEP 5 :
Type MV and Multiview and press enter select 3 view port and above and press enter and adjust the view in the view ports
RESULT :
The given challenge is done by using necessary tools in AutoCAD
