Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad

Q1. Create a layout of the Plan and Section A of the project in Challenges 7, using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot.

Work done as per above stated drawing. The drawig was prepared with the steps as mentioned in the question. Accordingly the snap shot of the plot was taken. The result as obtained is shown above. 

Q2. Create a layout of the Kitchen drawn in Challenge 9 as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot.

Work done as per above stated drawing. The drawig was prepared with the steps as mentioned in the question. Accordingly the snap shot of the plot was taken. The result as obtained is shown above.