Creation of Multiple viewports, Scaling the drawing and setting in Template in AutoCad
1.
AIM:- Create a layout of the Plan and Section A of the project in Challenges 7, using the template Tutorial-mArch.dwt in a scale as given in the Figure. Use the MV command to create the viewport of the size as shown in Figure. Also, use ATTEDIT command to edit the information in the title block. Use A1 size for the layout. Take a plot.
PROCEDURE:-
- For the first bolck draw a rectangle of the size (841 X 594 mm) as it is the standard size of the A1 size paper.
- Now explode the rectangle so that we can work on each line separetly.
- Now give offset of from right to left to create a title box.
- Now give offset to the horizontal lines to create boxes of the desired size.
- Now trim the excess lines and then the format of the title block is ready.
- Now as the sheet format is ready use the "DTEXT" of the desired/Preffered size to notate the boxes for what they are going to used for.
- Now use the command "ATT" to give the attribute definition to the following boxes.
- The dialogue box for the attribute definition looks as below.
- Do the same thing for all the boxes so that a proper format for the sheet is prepared.
- After entering all the attribute definition select the whole drawing and then enter command "B" to convert it into a block.
- By entering the data the drawing will turn into block.
- Now Select the drawing and scale it using "SC" command and then place it into the block.
- Scale the drawing with "0.02" to achive the scale of 1:50.
--------------------------------------------------------------------------------------------------------------------------------------
2.
AIM:- Create a layout of the Kitchen drawn in Challenge 9 as shown in Figure. Use the scale as shown in the Figure. Use A4 Size page for the layout. Take a plot.
PROCEDURE:-
- Take the drawing of the kitchen previously drawn into the challenge 9.
- Now select the layout 1 and then delete the excisting work in the layout.
- Now enter the command "PLOT" and select the size of the paper and then apply it to the layout.
- Now enter the command "MV" to create a viewport in the layout.
- Now create a view port according to the requirements and then add the other viewports and set all the viewports according to the requirements.
- For editing the view ports personally use command "MS". It helps to edit each view port individually.
- Creation of Viewport 1
- Creation of viewport 2
- Creation of viewport 3
- Creation of viewport 4
----------------------------------------------------------------------------------------------------------------------------------
3.
AIM:- Create a layout of the section created in Challenges 9.Use scale as mentioned in the Figure. Use MV command create multiple viewports. Take a plot.
PROCEDURE:-
- Take the drawing of the kitchen previously drawn into the challenge 9.
- Now select the layout 1 and then delete the excisting work in the layout.
- Now enter the command "PLOT" and select the size of the paper and then apply it to the layout.
- Now enter the command "MV" to create a viewport in the layout.
- Now create a view port according to the requirements and then add the other viewports and set all the viewports according to the requirements.
- For editing the view ports personally use command "MS". It helps to edit each view port individually.
- Creation of Viewport 1
- Creation of viewport 2
- Creation of viewport 3
