Challenge

Creation of Column Schedule and Drawing Template using AutoCad

AIM:TO CREATE THE WINDOW SCHEDULE AS PER THE GIVEN DETAILS.

INTRODUCTION : THE GIVEN WINDOW SCHEDULE CONTAINS THE WIDTH OF WINDOWS,THE SILL LEVEL AND THE LINTEL LEVEL ETC.

PROCEDURE:

GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
CLICK ON START DRAWING.
GO TO CREATE NEW DRAWING.
THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
USE THE DEFAULT IMPERIAL (FEET AND INCHES) SETTINGS
OPEN THE TEMPLATE AS ACAD.DWT
THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
WRITE LINE IN COMMAND TAB AND PRESS ENTER.
AS PER THE QUESTION CREATE THE TABLE USING LINE COMMAND.
DRAWING THE HORIZONTAL LINE BY ENTERING CERTAIN MAGNITUDE AS 20' AND PRESS ENTER.
BY USING OFFSET COMMAND SHIFT THE HORIZONTAL LINE BY 10' AND PRESS ENTER.
JOINING TWO HORIZONTAL L;INES AT CORNER POINTS AND PRESS ENTER.
THUS VERTICAL LINE IS CREATED .
USING OFFSET COMMAND SHIFTING THE VERTICAL LINES OF CERTAIN MAGNITUDE FOR 4SHIFTS AND PRESS ENTER.BLE IS CREATED.
USING TEST COMMAND ENTER THE DETAILS AS GIVEN.
CHANGING THE PROPERTIES OF TEST ACCORDING TO IT.

RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE TABLE CONTAINING THE DIFFERENT CONTENTS IS OBTAINED.

AIM:TO CREATE THE DRAWING TEMPLETE WHICH CONTAINS THE NOTE POINTS..

INTRODUCTION : TO CREATE THE DRAWING TEMPLETE WHICH CONTAINS THE NOTE POINTS.

PROCEDURE:

RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE TABLE CONTAINING THE DIFFERENT NOTE POINTS IS OBTAINED.

IM:TO CREATE THE DRAWING SCHEDULE AS PER THE GIVEN DETAILS.

INTRODUCTION : THE DRAWING SCHEDULE CONTAINS THE DIFFERENT DRAWING WHICH ARE REQUIRED.

PROCEDURE:

GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
CLICK ON START DRAWING.
GO TO CREATE NEW DRAWING.
THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
USE THE DEFAULT IMPERIAL (FEET AND INCHES) SETTINGS
OPEN THE TEMPLATE AS ACAD.DWT
THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
WRITE LINE IN COMMAND TAB AND PRESS ENTER.
AS PER THE QUESTION CREATE THE TABLE USING LINE COMMAND.
DRAWING THE HORIZONTAL LINE BY ENTERING CERTAIN MAGNITUDE AS 20' AND PRESS ENTER.
BY USING OFFSET COMMAND SHIFT THE HORIZONTAL LINE BY 10' AND PRESS ENTER.
JOINING TWO HORIZONTAL L;INES AT CORNER POINTS AND PRESS ENTER.
THUS VERTICAL LINE IS CREATED .
USING OFFSET COMMAND SHIFTING THE VERTICAL LINES OF CERTAIN MAGNITUDE FOR 4SHIFTS AND PRESS ENTER.BLE IS CREATED.
USING TEST COMMAND ENTER THE DETAILS AS GIVEN.
CHANGING THE PROPERTIES OF TEST ACCORDING TO IT.

RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE DRAWING TEMPLATE CONTAINING THE DIFFERENT DRAWINGS CON IS OBTAINED.

Ship work like this
in your own course.