Creating Walls, Partition walls and Floors for a residential layout using REVIT
Aim & Introduction:- My aim is make a residential floor plan given as per dimensons provided place components & elements. Arrange the components in proper way to look in asthetic way. To place the floor in for different levels using copy to clip board. To create floor using floor tab, give thickness & apply material. In this challenge i have commands draw walls , fillet, place components, placing stair case, edit bounderies for floor, slab, edit for stair case, create sections,set units, place grid lines, rename them , room tag, edit room name, its dimensions, create duplicates of families & edit as per requirements, give dimensions to rooms using annotate tab
1) Click on architecture tab click on grids keep the cursor on center of wall & drag vertically & place it & do same for other walls also. Now for horizontal grids do same but rename as A, B, C, D,E. Click on floor tab, drop down to floor structural, create boudary using pick lines, duplicate the family & edit thickness & apply material to it, apply, ok.
2) If walls are at different level keep unconstrained give heights for each walls. If walls are at one leves keep height constrained & do the layout. First of you should have to do basic planning & have take consideration of elements to provided its levels all other provisions to be provided like for plumbing, electrical fittings, applainces, keep elevation appearance, structural stability, cost of material, internal components provisions.
3) To copy the model elements & paste aligned to level 2 In level 2 drag from left to right on the plan & click on copy to clip board, drop down to aligned to selected levels a dailog box will appear & select on level 2 click ok. Create another level 3 to add roof slab in properties in under lay check range base to level 2, range top to level 3 & underlay oreintation to look down then level 2 floor plan will appear in level. Now in architecture click on floor drop down to structural floor & in modify tab click on rectangle one corener building to opposite corner & click on ok.
4) Open new architectural tab, set units to feet. Save the project information in manage tab & provide all deatils. Cick on architecture tab, click on wall, drop down to wall architectural, in properties tab click on basic wall, click on edit duplicate it wall - 9'' & edit thickness to 9'' & add material color to it, click o.k. Now draw with rectangle 40'-9'' x 34' keeping wall exterior. Now draw all rooms keeping wall interior as given - bed rooms - 10' x12'(guest room), 12'-4.5'' x 10', 13'-4.5' x 12', 13' x 12', kitchen - 9' x 13' - 5''. Now click on east elevation give level to 10' each & rename as ground first & terrace floor. Now room tags to all rooms & give dimension & rename them. Click on architecture, click on floor architectural drop down to floor structural, in properties tab drop down to floor basic edit duplicate the family rename as floor pcc , edit thickness to 100mm for pcc. In modify tab use pick lines give bounderies & also tile flooring duplicate the family rename as tile flooring edit thickness 50mm.Set bounderies using pick lines. Click on archetecture, click on stair case before that in properties tab click cast in place duplicate it as stair case edit staircase width as 3'-5'', tread as 10'', riser as 6'', landing thickness as 6'', waist slab thickness as 5''. Now place stair case exterior right for first flight, & exterior right as left for second flight. Now click on architecture tab, click on drop down to floor structural give bounderies in first floor plan & edit bouderies for staircase portion.Now click on architecture tab, click on component, drop down to place component place elements like bed, sofa, dinning table, kitchen counter, bath tub, shower.
KINDLY NOTE FOR 4TH QUESTION I HAD MADE THE MODEL BUT THE IS NOT UPLOADING DUE TO BIG FILE CAPACITY . SO ATTACHING PNG PHOTOS FOR THAT.