Drafting of various geometries using Chamfer, Fillet tool in AutoCad

1) First of all set drawing units, limits & set zoom all. Draw drawing using line & circle command set angle as per drawing using tracking settings.

2) First of all set drawing units, limits & set zoom all. Draw drawing using line command setangle as per drawing using tracking settings.

3) First of all set drawing units, limits & set zoom all. Draw drawing using line & circle command set angle as per drawing using tracking settings.

4) First of all set drawing units, limits & set zoom all. Draw drawing using line & command set angle as per drawing using tracking settings.

5) First of all set drawing units, limits & set zoom all. Draw drawing using line command set angle as per drawing using tracking settings. trim extra lines.

6) First of all set drawing units, limits & set zoom all. Draw drawing using rectangle, fillet, circle command set angle as per drawing using tracking settings. trim extra lines.

7) First of all set drawing units, limits & set zoom all. Draw drawing using circle command. In object snapping tick mark tan & draw as per drawing.

8) I could make this drawing because arc center line distance is not given.

9) First of all set drawing units, limits & set zoom all. Draw drawing using rectangle, offset command. Rotate inner rectagle to 45degree using polar settings.

10) First of all set drawing units, limits & set zoom all. Draw drawing using line command set angle as per drawing using tracking settings. trim extra lines.