Creating a Floor plan, Footing detail and Isometric view using AutoCad

1) Draw lines with xline command & gives distances as per drawing and trim extra lines. Use mtext command for description of drawing.

2) Draw lines with xline command & gives distances as per drawing and trim extra lines. Use mtext command for description of drawing.

3) Draw lines with xline command & gives distances as per drawing and trim extra lines. Use mtext command for description of drawing.

4) Draw lines with xline command & gives distances as per drawing and trim extra lines. Use mtext command for description of drawing.

5) Switch to 3d basics and set angle to 30,60,90,120 degrees. Draw lines as per shown drawing.

6) Switch to 3d basics and set angle to 30,60,90,120 degrees. Draw lines as per shown drawing.