Creating Kitchen layout, Hatching of Architectural elements and sectional view of an Industrial Building in AutoCad
1.Create the layouts of the Kitchen and provide hatches pattern as shown. Also, use blocks wherever required. Provide appropriate dimensions in the plan. Assume the size of doors, appliances and others as per the standards.
Aim ,
To create the layouts of the kitchen and provide hatches pattern.
Procedure and commands used ,
* Limits and units are fixed as per requirement.
* Measurements are taken as per the diagram .
* Hatches are also used wherever needed.
LINE ,
DIMLINEAR ,
MTEXT ,
HATCH
Diagram ,
2. Create the elevation of the plan created in the Challenges 7 and apply proper hatch in the walls, doors, windows, and other architectural elements. Refer to the dimensions in Plans and sections in Challenges 7.
Aim ,
To create the elevation of the plan created in challenge 7.
Procedure and commands used ,
* Limits and units are fixed as per requirement.
* Measurements are taken from the test 7 .
* Hatches are also used wherever needed.
* Elevations are made according to the plan 7.
LINE ,
DIMLINEAR ,
MTEXT ,
HATCH.
Diagram ,
3. Create the section view of an industrial building as shown in Figure. Provide appropriate hatches and dimensions wherever required. Also, provide annotations to the drawing.
Aim ,
To create the section view of the industrial building as shown in the figure.
Procedure and commands used ,
* Limits and units are fixed as per requirement.
* Measurements are taken as per the diagram .
* Hatches are also used wherever needed.
LINE ,
DIMLINEAR ,
MTEXT ,
HATCH.
Diagram ,
