Creating Bar Bending schedule, Different Door types, and Creation of standard drawing templates using AutoCad

1. Create the templates as shown in Figures. Take the size of the title block as per industry standards or you can assume it as per the size of the paper. Use text and attributes wherever required.

AIM ,

* To create the templates as shown in Figure.

PROCEDURE ,

* The units are setup to create a figure as required.

* Commands used in this are ,

* UNITS.

* LINE.

* MTEXT.

* OFFSET.

* LIMITS.

DIAGRAM ,

2. Create the doors type for warehouse as shown in the Figure. You need to create each door type as per standard size or given dimensions. Create the blocks of this door type after creating them.

AIM ,

To create a doors type for warehouse as shown in the figure.

PROCEDURE ,

* UNITS are setuped as required.

* LIMITS are also noted as required.

* Then using LINE command .

* OFFSET command is used wherever required.

* HATCH command is also used wherever required.

* DIMLINEAR option is used to measure the diagram drawn.

DIAGRAM ,

3. Create each symbol as a block with the name given in the legend. After creating the blocks arrange them in the legend as shown in the Figure.

AIM ,

To create each symbol as block with the name givwn in the legend.

PROCEDURE ,

* The units and limits are fixed for the diagram.

* Symboles are drawn using circle , polyline , rectangle command

* Line command is used to create line and Offset command is used wherever required.

* Hatch command is also used in required area.

DIAGRAM ,

4. Create the door type for residential building as a block. Save the name of the blocks as type. Use given dimensions or assume dimensions as per industry standards.

AIM ,

To create door type for residential building as block.

PROCEDURE ,

* UNITS and LIMITS are fixed for the diagram.

* LINE , OFFSET , ARC commands are used in this diagram .

* HATCH command is also used wherever required.

* DIMLINEAR command is used to measure the doors drawn.

DIAGRAM ,

5. Create each shape as a block as shown in the Figure. Save the block and insert them on the table as shown in the Figure.

AIM ,

To create a each shape as a block as shown in the figure.

PROCEDURE ,

* LINE command is used to create lines.

* OFFSET command , MTEXT command is also used wherever required.

DIAGRAM ,