Creating Architectural and Structural model with 3D rendering using REVIT
Q1:Select the type of structure you want to build from one of the three below:
a. Multi-Unit Residential Apartment
b. Office Buildings
c. School
Ans:School building
Q2:Assume reasonable assumptions for geographic and location details for your project modeling. Based on assumptions and type of structure selected identify the modeling requirements from NBC
Ans:For school building the height is 3.6m i.e.12feet
It is not in cold region
The room size should be more than 900ft sq.
Q3:Using the structural model, include the following components based on the type of structure selected
a. Foundation – Isolated / Wall/Matt Foundation
b. Columns
c. Beams Connected to Columns
d. Roof Framing/ Truss
e. Floor / Decks
f. Floor Openings for Elevators and Stairs
Aim and introduction:Using structural model components are selected
Procedure:
Steps:
- Go to the Revit
- New file
- Select structural template
- By using structural tab
- Draw the levels and grids
- Foundation is drafted
- Columns
- Beams
- Roof
- Floor
- Elevators and stairs
Results:Using structural model components are selected
Q4: a. Wall Layout with appropriate material and finishing
b. Exterior façade with fancy finish
c. Interior partition walls to size rooms
d. Components to add details to a room ( Desk, Chair, Lighting, Plumbing fixtures)
e. Add components such as stairs Elevators
f. Have at-least one side of the building with curtain walls and glass panels
g. Include interior and exterior lighting fixtures
h. Place proper topographic components from outside ( Trees, Parking, Plants) to add details to the model
Aim and introduction:By using architecture tab draw the components
Procedure:
Steps:
- Go to the architecture
- By components
- Load family
- And add the components
- Lightings
- Tables
- Trees etc.,
Results:By using architecture tab draw the components
5) Provide a set of drawings in an architectural and structural model to list the following details with categories and appropriate sheet templates included
a. Floor Plans with Annotations
b. Elevations
c. Sections
Aim and introduction:Showing floor plans, elevations and sections
Procedure:
Steps:
- Go to the property browser select the views
- For floor plans get floor views
- For elevations in all the direction get the elevations
- For sections go to thew view tab
- Add sections
Results:Showing floor plans, elevations and sections
6) Using the Rendering settings, Render images of the 3D model produced and include the rendered images to the drawing sheets
a. Rendering from interior rooms
b. Rendering from out showing topographic features
c. Rendering through structural framing
Aim and introduction:Rendering the images
Procedure:
Steps:
- Select the views
- Go to the render
- And select the modes
- Give Render
- Then it will get in Rendering gallery
Results:Rendering the images
Q7: Print the set of drawing sheets created and submit the drawings from the architecture and structure model
Aim and introduction:To template the drawings in sheet
Procedure:
Steps:
- Go to the sheets
- And select the view
- For sheets we have to insert the structural and architectural model.
Results:To template the drawings in sheet