Creating a Wardrobe detailed drawing, Floor Plan, Kitchen Layout and Column Detail using AutoCad
1)
AIM:TO CREATE THE FLOOR PLAN AS PER THE GIVEN DETAILS.
INTRODUCTION : THE GIVEN FLOOR PLAN CONTAINS THE BEDROOMS,CENTRE TABLE,UTILITY ROOM,POWDER RM,EIGHT SEATER DINING TABLE,STAIRCCASE ACCESSIBILITY ETC.
PROCEDURE:
- GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
- CLICK ON START DRAWING.
- GO TO CREATE NEW DRAWING.
- THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
- USE THE DEFAULT METRIC SETTINGS
- OPEN THE TEMPLATE AS ACAD.DWT
- THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
- THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
- USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
- WRITE LINE IN COMMAND TAB AND PRESS ENTER.
- CREATE THE LINES OF REQUIRED DIMENSIONS AND USING OFFSET COMMAND CREATE THE ROOMS.
- INSERT THE DOORS AND WINDOWS USING CREATE AND INSERT BLOCK .
- USING THE HATCH PATTERN INSERTING THE HATCH WHEREVER REQUIRED.
- USING MTEST COMMAND WRITING THE NAME OF ROOMS ETC.
RESULT:BY FOLLOWING THE ABOVE PROCEDURE THE GIVEN FLOOR PLAN IS DRAFTED.
2)
AIM:TO CREATE THE FRONT ELEVATION,CARCASE ELEVATION,SIDE ELEVATION AS PER THE GIVEN DETAILS.
INTRODUCTION : THE GIVEN FIGUES CONTAINS FRONT ELEVATION,SIDE ELEVATION OF CABINET ETC.
PROCEDURE:
- GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
- CLICK ON START DRAWING.
- GO TO CREATE NEW DRAWING.
- THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
- USE THE DEFAULT METRIC SETTINGS
- OPEN THE TEMPLATE AS ACAD.DWT
- THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
- THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
- USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
- WRITE LINE IN COMMAND TAB AND PRESS ENTER.
- CREATE THE VERTICAL LINE OF GIVEN DIMENSION,USING OFFSET COMMAND CREATE THE ANOTHER VERTICAL LINES.
- THUS ALL THE ELEVATIONS ARE OBTAINED.
RESULT:ALL TH4 ELEVATIONS OF CABINET ARE ONTAINED.