Creating a Layout, Section and Elevation with dimensions using AutoCad
.AIM:TO CREATE THE FLOOR PLAN AS PER THE GIVEN DETAILS.
INTRODUCTION : THE GIVEN FLOOR PLAN CONTAINS THE 7 BEDROOMS,STAIRCCASE ACCESSIBILITY ETC.
PROCEDURE:
- GO TO START MENU,SELECT INSTALLED AUTO CAD VERSION LIKE 2023.
- CLICK ON START DRAWING.
- GO TO CREATE NEW DRAWING.
- THEN NEW TAB WILL OPEN AND IT SHOWS FOUR ICONS.
- USE THE DEFAULT METRIC SETTINGS
- OPEN THE TEMPLATE AS ACAD.DWT
- THEN NEW DRAWING TEMPLATE IS CREATED AND SET THE LIMITS AND PRESS ENTER.
- THEN WRITE ZOOMIN IN COMMAND TAB AND PRESS ENTER,TEMPLATE IS CREATED .
- USING UNITS IN COMMAND TAB,SELECT THE UNITS YOU ARE GOING TO DRAFT.
- WRITE LINE IN COMMAND TAB AND PRESS ENTER.
- PLACING THE COLUMNS OF GIVEN SIZE ON SHEET.
- BY ASSUMING WALL THICKNESS EXTERNAL 230MM AND INTERNAL 150MM.
- BY USING THE LINE COMMAND AND TAKING THE COLUMNS REFERENCE ,CREATING THE GIVEN ROOMS.
- AFTER CREATING THE ROOMS USING TEST COMMAND WRITING THE NAMES OF ROOMS.
- CREATING THE DOORS IN THE REQUISITE POSITION USING CIRCLE COMMAND FOLLOWED BY TRIM COMMAND TO OBTAIN DOOR SHAPE.
ESULT:BY FOLLOWING THE ABOVE PROCEDURE THE TABLE CONTAINING THE DIFFERENT CONTENTS IS OBTAINED.