Benchmarking

Aim: To Design & Develop the Back Door Panel of a car using a styling surface as input and also creating the necessary reinforcements and embosses. Introduction: Back Door: The back door is placed at the rear end of a car at which the loads can be kept. It is also called a trunk or tailgate. It consists of an outer…

Aim: To design & develop the Roof of a car with its components by following the master section and design parameters. Objective:   To develop the essential flanges and reinforcements using roof styling as input.   To do a curvature study on the roof and perform calculations to determine the position of the…

Section Modulus calculation and optimization Aim:   To generate the report on finding the section modulus for the hood design and improving it based on the input and increasing the strength of the hood by using the CATIA V5.   Section Modulus:   It is a geometric property for a given cross-section used in…

Aim : To design a front fender from the given skin data and the master section provided with Drip mounting, A-pillar, Sill, Bumper, and Cowl mountings. Theory : What is Fender? A fender is a part of the automobile that is placed just above the tires/wheels (both at the front & back). The purpose of the fender in an…

                                                                    HOOD DESIGN Aim: To design a hood inner panel. To design hood outer panels with them.…

                                                                                           …

Project Objective :-  In This Project, I am Going to Suggest a Big Car for Mr.D.S. Pugazhendhi Under 8 to 10 Lakhs on Road for Official and Family Purpose Traveling Distance Around 500km.   Suggested Cars Listed Below :-      TATA ALTROZ (XT DIESEL). TATA NEXON  (XE DIESEL). MAHINDRA XUV 300…

                                                               DEVELOPMENT OF A DOOR TRIM PANEL   AIM : To Create a CAD model considering the following inputs as in OEM and tier1 companies. Class A surface. Nominal thickness with reference of Master Sections. Attachment strategy. INPUT : Class A Surface. Master Sections.…

                                                                   MASTER SECTION DEVELOPMENT   AIM - To design B-Pillar lower using Master…

                                                                                              DOOR APPLIQUE DESIGN WITH ENGINEERING FEATURES   AIM:- To create a door applique design from the given class A surface and to create engineering Features to fit the component in the main surface.   OBJECTIVES: -   The tooling…

                                                                                           …

                                                          Attachment Feature Creation   Aim : - To make a rib on coin holder component and draft analysis is checking.   Procedure : -    Select the faces on coin holder component to  create sketches.   Create the sketch of a rib.   Extrude the rib sketch of in any direction…

                                                              SWITCH BEZEL CORE AND CAVITY    AIM :- To Create core and cavity for switch bezel component.…

                                                                      CENTER CONSOLE COIN HOLDER Aim :- The Main objective is to perform a draft…

                                                                       Switch Bezel Design      Aim:-  The main objective…

                                                                     Door Armrest   Aim :- The Main objective is to perform a draft analysis…

Base Bracket Design   Aim:-  The main objective is to perform a draft analysis and make into a solid particle the given CAD model.   Procedure :-    Open the CAT part, for doing the operation of draft analysis. Select file click ok, and open the CAT part. Before doing the drafting analysis, make…

Draft Analysis on a Fan Cover Aim :- The main objective is to perform a draft analysis on the given CAD model.   Procedure :-    Open the CAT part, for doing the operation of draft analysis. Select file click ok, and open the CAT part. Before doing the drafting analysis, make sure that the whole part is…