Advanced Sheet Metal Design Using NX Cad Challenge_7_ Metal bracket-II

Title of the Project

MAKE BRACKET USING ADVANCE FLANGE AND CUTOUT:

Objective

TO CREATE FLANGE USE VARIOUS BEND AND CUTOUT ABD HOLE FEATURE ALSO USING GUSSET FEATURE

Introduction 

sHEET METAL DESIGN, it is a very big industry, in each and every component , vehicle, utensile, cars, buses, mahcines, sheet metal part is used. sheet metal we count thickness fromn 0.5mm to 6mm. in fabrication we use sheet metal part, and we bend it using press brake. 

 we have already blank size, ( flat pattern before bending)  then we bend it. the bending radius that also punch radius should be more than or equal to its thickness.

Design methodology / approach (To be explained with the help of Flowcharts only)

SKETCH ON FRONT AND RIGHT PLANE-> CUTOUTS->UNBENDING->BREAK CORNERS->ADVANCE FLANGE-> GUSSET->REBEND

Description (Need to explain tools/ Features used while designing)

CREATE FOLLOWING SKETCH ON FRONT PLANE:

MAKE ANOTHER SKETCH ON RIGHT PLANE

MAKE COUNTER FLANG AS SHOWN:

CUTOUT AS SHOWN: 

NOW, UNBEND AFTER CUTOUT DONE :

MAKE AOTHER CUTOUT AND REBEND IT:

NOW MAKE FILLET AT CORNOR TO SHARP CORNORS:

USE ADVANCE FLANGE :

MAKE CUTOUT AS SHOWN:

MAKE DVANCE FLANGE 

MAKE GUSSET :

Upload a min of four screenshots of Model in the report. (Front View, Side View, Isometric View and the Top View)