Advanced Sheet Metal Design Using NX Cad Challenge_6_Bracket
BRACKET DESIGN IN NX CAD USING SHEET METAL APPLICATION
OBJECTIVE
To create a bracket from a 2d drawing using NX CAD sheet metal application.
INTRODUCTION
A bracket is designed from given 2d drawing using basic commands in NX CAD sheet metal workbench .
DESIGN METHODOLOGY
DESCRIPTION
- Sketch – It is a 2d figure drawn . It is drawn in XZ Plane .
- Contour Flange – A flange is created by extruding the sketch .
- Normal Cutout – A sketch is cut normally on the surface by this .
- Break Corner – This is used to make the sharp edges round .
- Unbend – The figure is unbended in order to create a bead .
- Bead – A bead is done on the figure . It lifts up sketch and simulates a stamping tool.
- Simple hole – Three simple holes are created .
- Rebend – The figure is rebended .
- Flat Pattern – It is created to check the manufacturing feasibility .
FRONT VIEW
TOP VIEW
SIDE VIEW
ISOMETRIC VIEW
CONCLUSION –
A bracket has been made according to the given 2d figure provided .