Adams challenge 4 - suspension creation

PROCEDURE :

1. We first open the ADAMS CAR software in expert mode to access the template files and to create a suspension system from scratch.

2. We then import the double wishbone template file in the expert mode and then save it to the required database.

3. We then open the subsystem setup under the standard interface mode and we import the front double wishbone supension susbsystem creating a new subsystem and saving this suspension system into the database of that of the template file.

4. We then open the new assembly file where we should import our template file and the subsystem file. This results in assembling our double wishbone template system and subsystem to obatin the required front double wihsbone suspension sytstem.

5. To verify our assebmly, a parallel wheel simulation is performed at certain rebound and jounce travel of the wheel. The simualtion runs in the required sequence and hence validates our results.