Automobile roof

NOTE: “THIS IS A RE-SUBMISSION AS PER THE GUIDELINES GIVEN BY Mr.AKSHAY” AND THE BELOW ATTACHED PHOTOS AND IGS FILE ARE THE TOKEN OF PROOF THAT CHALLENGE HAS COMPLETED AND I AM EXPECTING THE SAME SCORE WHICH WAS ALLOTED BEFORE. FENDER DESIGN:- Objective is to:- Design Drip Area, Design Sill Mount Area Design…

Section Modulus calculation and optimization OBJECTIVE: To calculate the section modulus for the previously designed hood and optimized hood. To come up with the new section that has improved section modulus of the previous section. Section Modulus is given by the formula:- S = I/y Where, S = Section Modulus I = Moment…

Backdoor is generally constructed with stamping of aluminum or stain less steel sheet of thickness 0.75(min) is used. The backdoor is usually made with multiple selections of materials depending on the budgeting constraints of the vehicle. Steel is the most commonly used material, while aluminum though lighter has a higher…

Automobile roof An automobile roof or car top is the portion of an automobile that sits above the passenger compartment, protecting the vehicle occupants from sun, wind, rain, and other external elements Roof is connected to A-pillar, B-Pillar and C-Pillar to cover the Front and rear door. Roof…

                                                        HOOD Hood is an important component of the front portion of the car which is used for many purposes. It is made aerodynamic…

I would suggest TATA NEXON 

                                                     Underbody Coating In Indian road conditions, a cars underbody is most prone to corrosion. Underbody coating provides long term protection…