21. Wiring harness design in CATIA V5 - 3D modeling Week 4 Challenge
Objective:
To route the given harness layout in the electrical workbench and add protective covering on all the branches connected to DT06-2S & DT06-4S connectors
So Initially I made a skeleton Using Part Drawing
Given connectors
1.DT06-4S
2.DT06-6S
3.DT06-2S
4.DT06-08SA
So as per requirement, we have Downloaded the connectors from TE.com which are shown as follows
1.DT06-4S
Connector Connection Point
Bundle Connection Point
2.DT06-6S
Connector Connection Point
Bundle Connection Point
3.DT06-2S
Connector Connnection Point
Bundle Connection Point
4.DT06-08SA
Connector Connection Point
Bundle Connection Point
STEPS
1. These 4Clips are geometrically and electrically defined.
2. Then All 6 clips are first added into mechanical assembly and positioned at end points of the skeleton branches using manupulation but here I have used constraints method.
3. After positioning at proper locations start routing process.
4. After routing add corroguted tubes as protection
SO FINAL ROUTING IS
ALL PARTS ARE ADDED IN A ZIP FILE ATTACHED BELOW