Create the 1D elements on the following component with given cross-section and DOF (HYPERMESH)
OBJECTIVE :
TO Create 1D elements on the following component with given cross-section and DOF
a. Rod element:- with only translational DOF and RBE2 link
Cross-Section: BOX- Dimension a= 12 mm
dimension b=10 mm
Thickness t= 0.75 mm
b. Beam element:- with all DOF and RBE3 link
Cross-Section: I Section- Dimension a= 8 mm
Dimension b= 10 mm
Dimension c= 8.5 mm
Thickness t1= 0.75 mm
Thickness t2= .6 mm
Thickness t3= .6 mm
c. Bar element:- with only x and y DOFs With RBE3 link
Cross-section: CROSS section- Dimension DIM1= 5 mm
Thickness DIM2= 1.2 mm
Dimension DIM3= 10 mm
Thickness DIM4= 1.2mm
d. & e. apply the mass of magnitude 10 with RBE2 link
f. Join the two components with Spring elements.
PROCEDURE:
12. Geom > autocleanup > surfs > all > autocleanup > return.
14. F12 > surfs > all > element size 5 > mesh > return.
15. 1d > rigids > multiple nodes > calculate nodes > by path > check dof 1, dof 2 and dof 3 > create nodes around the circular areas A.
17. 1d > rbe3 > check only dof1 and dof2 > nodes > by path > create nodes around the circular areas C.
19. 1d > hyper Beam > standarad section > standard I section > create > enter all the dimensions given for beam element > rename the section as BEAM.
20. Entities > Create > Standard Section > optistruct > CROSS > Enter all the dimensions given for bar element > rename the section as BAR.
21. Entities > Create > Standard Section > optistruct > box > enter all the dimensions given for rod element > rename the section as ROD. Model View to return to the main page.
22. Features tree > create > property > BEAM > change card image to PBEAM > material > steel > beam Section > BEAM.
23. Features tree > create > property > BAR > change card image to PBAR > material > Steel > beam Section >BAR.
24. Features tree > create > property > ROD > change card image to PROD > material > steel > beam Section > ROD.
25. 1d > rods > elem types=CROD > property > ROD > select the nodes in the region A > CROD element is created.
26. 1d > bars > elem types=CBEAM > property > BEAM > select the nodes in the region B > CBEAM element is created.
27. 1d > bars > elem types= CBAR > property > BAR > select the nodes in the region C > CBAR element is created.
28. 1d > masses > MASS=10 > Elem types=CMASS1 > select the nodes in the region D > create. As same as area E.
29. 1d > springs > elem types=CELAS1 > select the corner nodes in both side of the F regions > spring element is created.
30. Click Shaded Elements and Mesh Lines.
31. The final image is shown in below.
RESULT AND CONCLUSION:
1. Therefore, Bar Rod Beam and spring elements are created in the component from the given cross-section and DOF's using midsurfacing and meshing options.