Details  Reports of Meshing:- First of all go mesh section select length  go to peremiter then goto box selection then middle click then type length (1) dimension then click ok then select macro then goto box selection then middle click then type length (1) dimension then click ok then go to top…

https://drive.google.com/file/d/1GCaqifnQTR0arCpEhHyP9mhSv16NUXqk/view?usp=share_link   PLease find the attached file TURBOCHARGER:    A Turbocharger is in the form of forced induction which forces the air into the Internal Combustion Engine. It increases the amount of air entering the engine to create more…

  https://drive.google.com/file/d/1V3TW_CtgJjaCwnxnVMYPezZsGJGlfxga/view?usp=share_link Objective:       The goal is to clean the surface geometry to avoid errors and create a surface wrap that accurately captures the input domain geometry (a powertrain control) with high-quality cells so as to make…

    CFD meshing on BMW car   Aim: For the given model, check and solve all geometrical errors on half portion and Assign appropriate PIDs. Perform meshing with the given Target length and element Quality criteria. After meshing the half model, Do symmetry to the other side.   Objective: - Target…

https://drive.google.com/file/d/1rk1weXBllk78twg0kDyBD_U4sWdQQo-N/view?usp=sharing   Objective : To Identifying & cleanup all the topological errors in the given Tesla Cyber Truck Car model. To create a surface mesh. To Create a wind tunnel around Tesla Cyber Truck Car . To create a volumetric mesh to…

   Mixing Tee Description:  Mixing tee is a flow control devices.It mixes the two different fluid stream into a combined fluid stream.In has two inlets and one outlet.In this two inlets, one is located along the X axis and the other is located along the Y axis.The outlet is located along the X axis. Formula:…

Flow over a Cylinder    Aim Simulate the flow over the cylinder and explain the phenomenon of Karman vortex street. Firstly, Simulate the flow with the steady and unsteady case and calculate the Strouhal Number for Re=100 Secondly, calculate the coefficient of drag and lift over a cylinder by setting the Reynolds…

Aim : The aim is to understand the Rayleigh taylors instability phenomena and how it takes place. Objective : Some practical CFD models that have been based on the mathematical analysis of Rayleigh Taylor waves. Explain how these mathematical models have been adapted for CFD calculations. Perform the Rayleigh Taylor instability…

Objective: 1. Describe Ahmed's body and its importance. Q2. Explain the reason for the negative pressure in the wake region.  Q3. Explain the significance of the point of separation.    Expected results: 1. Velocity and pressure contours.  2. The drag coefficient plot for a refined case. ( For a velocity of 25m/sec, the…

Aim: To study the Conjugate Heat Transfer Analysis of Exhaust Port using ANSYS Fluent. OBJECTIVES The objectives of the simulation are Simulation of Conjugate heat transfer on exhaust manifold Calculation of wall heat transfer coefficient on internal solid surface Maintaining appropriate y+ value for the turbulence model…

Aim: Perform a steady-state conjugate heat transfer analysis on a model of a graphics card. Objectives: Run the simulation by varying the velocity from 1m/sec to 5m/sec for at least 3 velocities and discuss the results. Find out the maximum temperature and heat transfer coefficient attained by the processor. Prove that…

Objective :-To derive the following 4th order approximation of the second order derivative usingCentral differenceSkewed rigth-sided differenceSkewed left-sided differenceFirst step is to find the number of nodes required for deriving each difference method using the given formula.After deriving all the difference method,…