Benchmarking: Benchmarking is a process of measuring the performance of a company's products, services, or processes against those of another business considered to be the best in the industry. It also helps to improve or give the best results in the product compared to the competitors. Case Study: Mr. D.S. Pughazhyendhii is…

Under-Body Coating: Underbody coating is usually a dense cladding (often based on rubber) applied uniformly to the undercarriage of the automobile. It is normally sprayed or painted on when the car is just out of the dealership and is clean. But even if you are getting the undercoating applied after a couple of years,…

Aim: To design hood outer panel, inner panel and reinforcements with the given outer hood skin, master section and design parameters. Introduction: The hood or bonnet is the hinged cover over the engine of motor vehicles. Hoods can open to allow access to the engine compartment (or trunk on rear-engine and some mid-engine…

Section Modulus :   Objective: To find the section modulus of the hood and optimisation to improve the overall section modulus. Section Modulus: The section modulus (S) is geometric property of the cross section used for designing beams and flexural members. It does not represent anything physically. Formula of Section…

Objective: In this challenge to Calculate the Wheel Arc area and prove whether the car will pass the standards or not. Given part file of Wheel Arch: Introduction: Wheel Arch: It is a semicircular profile above wheels designed for enclosing tire within the fender The wheel arch is designed considering all possible motions…

FENDER DESIGN AIM: To design a  front fender of a car by following the given master section as per the design considerations of OEM. FENDER: It is an aesthetic component/part of a car that frames the wheels. Prevention of sand,  mud particles, and other road contaminants from being thrown into the engine…

AIM:  To design a roof with all the components like front roof rail, rear roof rail, and bow roofs by following the given master sections and the high-quality surface, considering all the design requirements as per the OEM standards. ROOF: An automobile roof or car top is the portion of an automobile that sits above…

Aim: To design the Back door of the car using the appropriate design methodologies, providing the necessary Reinforcements and embosses in the inner panel for strength. Design Considerations for a Back Door: Rear Visibility for Functionality and Safety. Boot Space and Accessibility. Type of Backdoor Opening (For individual…