MIX DESIGN PROJECT 1 AIM:                 To calculate the mix design for M35 concrete with flyash. ASSUMPTIONS: Grade of concrete – M35 Type of cement – OPC Type of admixtures – Flyash Maximum nominal size of aggregate –…

1. G+1 floor plan as per Vaastu Shastra     The structural drwings required for a construction are stated below 1. centre line drawing 2. footing and column layout with reinforcement details. 3. column schedule with reinforcement details. 4. plinth beam layout with reinforcement details 5. first floor beam layout…

Create the geometries from P1 to P2 using all the coordinates system methods. You need to use the Line tool to create the geometries. Where required you need to use the circle tool. Please read the drawings and find out the missing dimensions before working on the sketches.   AIM:  (A) To create the geometries…

AIM: To create cross section of wall over a footing as given in C1. Commands used: Line. Rectangle. Trim. PROCEDURE: Specify the first corner point as (5,5) Specify the length of rectangle =0.9 units in command box Specify width of rectangle =0.25 units in command box Specify the first corner point which is 0.2 units from…

  Commands used in this challenge are Line Circle Rectangle Copy Mirror Offset Trim Polygon Point Rotate Fillet                                            DIAGRAM 1   Aim: To draw the given figure…

1) Based on the project saved from Week 3, proceed from the First Floor Level. Model a Ceiling from the architecture tab above the walls at the first-floor level AIM:  To model a Ceiling from the architecture tab above the walls at the first-floor level. INTRODUCTION: The creation of Ceilings within Revit is a very similar…