PART – 1   Objective Complex gating system to accommodate 8 molds using only one sprue. Procedure Following is the process to perform complex gating system: Create a ruler of dimension (40x10) mm and perform dual domain mesh by taking value of 1 mm as global edge length as shown below Add cold gate to the centre…

Objective Obtain the result of a fill+pack+warp analysis on the model and from the result identify the main contributing factor for the warpage on the model. procedure following is the process to obtain the results: Create model with having specification given below: Base diameter = 100 mm Top diameter = 160 mm Height…

Objective Run a cool analysis on the ruler geometry. Compare the result of the cool analysis by using a normal cooling circuit and a chiller circuit and also check the deflection based on the choice of cooling circuit. Procedure Following are the process to get the result: Create a normal cooling circuit and chiller circuit:…

UNDER BODY COATING:   We all are aware of the fact that the underbody of the previous models was made from durable metals such as steel, which is easily damaged and oxidized, forming rust While you are sitting on the driving seat enjoying the smooth ride, the underbody of your car is always exposed to muddy water,…