Alexander Chikomo Chikomo
Skills Acquired at Skill-Lync :
8 Projects
Week 1 Understanding Different Battery Chemistry
Please find my attached Week 1 Challenge
05 Jun 2020 05:12 PM IST
Week 5 Battery characteristics using drive cycle
Week 5 Challenge submitted
07 Jul 2020 10:39 AM IST
Week 6 Fuel cell powered vehicle model
MATLAB model of Fuel Cell powered electric vehicle and results analysis The basic principle of a Fuel Cell car is that, a fuel cell is used to produce an electro-chemical reaction. Hydrogen from the fuel tank and oxygen from the air combins, during the reaction electricity is produced. In a (PEM) Polymer Electrolyte…
15 Jul 2020 10:03 PM IST
Week 7 State of charge estimation
Coulomb counting is a technique used to track the State of Charge of a battery pack. The name “coulomb” was given in honor of Charles-Augustin de Coulomb (1736–1806) who is best known for developing Coulomb’s law. It works by integrating the active flowing current (measured in amps)…
24 Jul 2020 11:06 PM IST
Week 8 Multi cell Battery Pack
WEAKEST/FAULT CELL Weakest cell limits the usable capacity of the battery pack. Any element which is imposing certain limitation of charging and discharging battery pack, it imposes a limit on overall operation, due to to weakest cell reaching the limit earlier than others, battery pack is going to…
27 Jul 2020 11:12 PM IST
Week 10 Thermal Management
Thermal management of battery systems in electric vehicles is critical for maintaining energy storage capacity, driving range, cell longevity and system safety. The thermal control will provide better cell/module temperature uniformity, less complicated design and a safer system. The heat generation phenomena and…
08 Aug 2020 10:27 PM IST
Project 1 Mechanical design of battery pack
Abstract This project is about mechanical design of Lithium-ion battery pack consisting of 18KWh. The cell name used in preparation is ANR26650M1-B, necessary assumptions were considered during building the cell then a module and finally a battery pack was developed. The battery model in MATLAB is configured, simulation…
21 Aug 2020 08:56 AM IST
Project 2 Thermal modeling of battery pack
Introduction Thermal management of battery systems in electric vehicles is critical for maintaining energy storage capacity, driving range, cell longevity and system safety. The thermal control will provide better cell/module temperature uniformity, less complicated design and a safer system. The heat generation…
04 Sep 2020 11:11 PM IST
1 Course Certificates
Introduction to Battery Technology for Electric Vehicle
Here are the courses that I have enrolled
Similar Profiles
Ladder of success cannot be climbed with hands in pocket.
The Future in Motion
Give more than what you get you will get more than what you gave
Avid learner