Wiring harness routing & packaging Rules Week 3 Challenge

Steps.

Once the File is Downloaded, Open the File Using CATIA V5

Using the Part design model, we define entry, Exit, Base points, and Planes

After determining the points and planes open the file in Electrical Part design

Now we need to define the part as a Support using the Define support Part

Here we use the Required points and planes as an Entry and exit of the clamp for one side

And use the support definition again to give an entry point on the opposite side by selecting the point opposite of the first support definition while keeping the base plane the same

(Note: if you face any issue with point definition, or point selection, Right-click on the point definition window and use the reset option.)

After providing the necessary properties Save the file.

P clamp

 Q2.)

 Steps.

Once the File is Downloaded, Open the File Using CATIA V5

Using the Part design model, we define 2 points as the Bundle entry and Connector connection point with Axis

After determining the points and planes open the file in Electrical Part design

Now we need to define the part as a Backshell using Define Back shell Feature

After defining it as the Backshell we need to define the connection points

End, where the Back shell is connected with the connector, is defined using Define Back Shell Connection Point Feature

End where the bundle is connected to the back shell defined using Define Bundle Connection Point Feature

After giving the necessary properties Save the file.

Ex; tyco

Q3)Steps.

Open CATIA V5 with Electrical Part Design Model

Using Define Protection Part

Select the type as Corrugated Tube

Give the Required Parameters (Inner dia, Thickness, Bend Radii( Bend Radii= 1.5 times the OD))

Click on OK

After giving the necessary properties Save the file.