Wiring harness routing & packaging Rules Week 3 Challenge
Q1. Download following clip cad data & define it as Electrical support using Electrical Part design Workbench. Define all the necessary properties.
Answer:
Hellarmann Tyton – 21160129 That 3D part not avilable in the website..So I downoad stiky Clamp To Add the necessary properties to the 3d part
-Download the 3D file Then Create the Geometrical properties like Point,Planes in the Part design workbench once it is completed then go Electrical Part design work bench Define the Support part for clamp click the intal point & plane (Entry Point of Wire Routing ) in the same way second plane (Exit Point of wire routing) then select the base plane in the same way to define the Entry point to Exit point in becuse in some cases the clamp may be fited in either side of Device like Car body ,Control Box any of them so we define both side consider in Entry point & place to Routing Climp.
Next save it Catlogue for Harness Routing Clips
Q2. Download following Back shell cad data & define it as Electrical back shell using Electrical Part design Workbench. Define all the necessary properties.
Answer:
Downlaod the Step file in the Website then Create the the geometrical properies the Back shell like Point & axis creation so it is easly navigate to Electrical Properies
Defin the part as a Back shell once it defines add the Back shell connection & Bundle Connection point to the part & save it the Catlog.
Q3. Create Following Corrugated tubes & Add them in Catalogue under “Slit COT” family.
|
Name |
ID (mm) |
OD (mm) |
Thickness (mm) |
|
15mm COT |
12 |
15 |
1.5 |
|
20mm COT |
17 |
20 |
1.5 |
|
35mm COT |
32 |
35 |
1.5 |
|
10mm COT |
7 |
10 |
1.5 |
|
5mm COT |
3 |
5 |
1 |
Answer:
File select New Part creation then add the name Cot_20 part file creted then check its in Electrical part workbench then click then click the Cot-20 part body or top of the icon the click the Protection part Define command it ll ask the parameters like Internal dimeter of the Tube ,Thickness, Bend radius... Once you put the ID & Thickness of the corrugated tube it will take directly OD outer diameter of the Corrugate tube after that you check in measures
If i put ID=12mm with Thickness of 1.5mm it will take 15mm
12+1.5+1.5=15mm (1.5mm thickness should be consider on bothside of the tube )Software also it will take as per our calucation.